TSX-V:
GBR
VANCOUVER, BC, March 29, 2021 /CNW/ - Great Bear Resources Ltd.
(the "Company" or "Great Bear", (TSXV: GBR) (OTCQX: GTBAF) today
reported results from its ongoing fully funded $45 million 2021 exploration program at its 100%
owned flagship Dixie Project in the Red
Lake district of Ontario.
Expansion of the LP Fault
- Deep drilling has doubled the drill-confirmed vertical
extent of the LP Fault gold zone, which begins at bedrock
surface, to approximately 800 vertical metres. The area of
ongoing grid drilling extends along 4 kilometres of strike
length. Figure 1 and Figure 2.
- Three new 400 – 450 metre step-down holes drilled along
500 metres of strike length all successfully intersected
the continuation of the LP Fault host rocks and gold mineralization
at depths of 700 – 820 vertical metres.
- Gold grades and mineralized zone thickness were better at
depth on two of three tested drill sections.
- Initial deep drilling tested below the most weakly
mineralized segment of the LP Fault, formerly referred to as
the "Gap" zone (February 13,
2020).
- Large scale step-out drilling at depth, including
below areas of high-grade gold mineralization, will continue
throughout 2021.
High-Grade Gold in the First Deep LP Fault Drill
Holes
- High-grade gold was intersected at depth in two of
the three deep drill holes, with better grades and thickness than
previously observed in the near surface. All three deep drill
holes contained multiple intervals of gold mineralization.
Table 1 and Table 2.
- BR-260 is the deepest LP Fault drill hole to date.
It assayed 15.57 g/t gold over 3.05 metres from 942.20
to 945.25 metres, within a broader interval of 1.08 g/t gold
over 70.25 metres from 906.15 to 976.40 metres. Figure
3 and Figure 4.
- While high-grade intervals are the primary drill targets at
these depths, the dual high-grade and bulk-tonnage character of
the LP Fault gold zone remains strongly developed at
depth.
- Oriented core data collected from these initial deep holes will
assist with determining controls to higher grade panels
within the broad envelope of gold mineralization.
Great Bear has now published results from 270 LP Fault
drill holes and anticipates at least 130 additional LP Fault
drill holes will be completed by the end of 2021, for a total of
at least 400 drill holes.
Chris Taylor, President and CEO
of Great Bear said, "We drilled below the most weakly mineralized
segment of the LP Fault with our first deep holes, and discovered
better gold mineralization at depth. After 270 drill holes we
have yet to find the limits of the LP Fault's gold mineralization.
Mesothermal gold systems of this type, particularly in the
Red Lake area, can extend
vertically over kilometres. We are currently working with
in-house and external modelers to finalize 2021 drill plans, and
will provide guidance over the coming weeks on expected timing of
delivery of initial estimates of mineral resources."
Figure 1 (Top): Long section of
the LP Fault zone showing the locations and depths of the new deep
drill holes (labeled). Figure 2 (Bottom)
: Map of current drill results showing the location of the
new deep drill holes.
Table 1: Drill holes released to date
on section 21450 showing increased gold mineralization grades and
widths with increasing depth in the former "Gap" zone. See
news releases of April 9, 2020 and
May 4, 2020 for previously reported
drill holes. New results from BR-260 in italics.
Drill
Hole
|
|
From
(m)
|
To
(m)
|
Width*
(m)
|
Gold
(g/t)
|
Vertical
Depth (m)
|
BR-078
|
|
176.00
|
212.90
|
36.90
|
0.42
|
150
|
BR-097
|
|
255.00
|
259.00
|
4.00
|
1.39
|
220
|
|
and
|
391.70
|
393.50
|
1.80
|
3.49
|
335
|
BR-098
|
|
419.70
|
448.50
|
28.80
|
0.65
|
365
|
|
and
|
493.25
|
495.05
|
1.80
|
9.90
|
425
|
BR-260
|
|
906.15
|
976.40
|
70.25
|
1.08
|
760
|
(new)
|
including
|
942.20
|
945.25
|
3.05
|
15.57
|
790
|
* Widths
are drill indicated core length, as insufficient drilling has been
undertaken to determine true widths at this time. Average
grades are calculated with un-capped gold assays, as insufficient
drilling has been completed to determine capping levels for higher
grade gold intercepts. Interval widths are calculated using a
0.10 g/t gold cut-off grade with up to 3 m of internal dilution of
zero grade.
|
Table 2: New drill results from the
first three deep holes into the LP Fault system along 500 metres of
strike length in the "Gap" area.
Drill
Hole
|
|
From
(m)
|
To
(m)
|
Width*
(m)
|
Gold
(g/t)
|
Section
|
BR-260
|
|
906.15
|
976.40
|
70.25
|
1.08
|
21450
|
|
including
|
929.30
|
948.00
|
18.70
|
3.33
|
|
|
and
including
|
929.30
|
929.80
|
0.50
|
16.50
|
|
|
and
including
|
942.20
|
945.25
|
3.05
|
15.57
|
|
|
and
including
|
942.20
|
942.80
|
0.60
|
73.10
|
|
BR-261
|
|
624.85
|
638.50
|
13.65
|
0.57
|
21200
|
|
|
747.15
|
761.00
|
13.85
|
0.44
|
|
|
|
811.60
|
823.25
|
11.65
|
0.96
|
|
|
including
|
822.00
|
823.25
|
1.25
|
5.62
|
|
|
and
|
835.00
|
839.50
|
4.50
|
1.17
|
|
BR-262
|
|
871.00
|
876.50
|
5.50
|
1.19
|
21700
|
|
and
|
933.50
|
950.50
|
17.00
|
1.04
|
|
|
including
|
946.50
|
948.50
|
2.00
|
7.27
|
|
|
and
including
|
946.50
|
947.50
|
1.00
|
12.30
|
|
* Widths
are drill indicated core length, as insufficient drilling has been
undertaken to determine true widths at this time. Average
grades are calculated with un-capped gold assays, as insufficient
drilling has been completed to determine capping levels for higher
grade gold intercepts. Interval widths are calculated using a
0.10 g/t gold cut-off grade with up to 3 m of internal dilution of
zero grade.
|
Figure 3: Section 21450 showing
BR-260, the deepest drill hole in the LP Fault to date. This
section is located in what was formerly referred to as the "Gap"
zone.
Figure 4: The deepest drill hole in the LP
Fault to date. 73.10 g/t gold over 0.60 metres at 942.20
metres down hole in BR-260 (790 metres vertical depth). The
shear-zone hosted disseminated high-grade gold with sparse
accessory sulphides within a felsic volcanic host matches
mineralization at shallower depths within the LP Fault. Image
is of a selected interval and is not representative of all gold
mineralization on the property.
Great Bear's progress can be followed using the Company's plan
maps, long sections and cross sections, and through the VRIFY model
posted at the Company's web site at www.greatbearresources.ca,
which will next be updated in Q2 2021. All LP Fault drill
hole highlighted assays, plus drill collar locations and
orientations can also be downloaded at the Company's web site.
Drill collar location, azimuth and dip for drill holes included
in this release are provided in the table below (UTM zone 15N, NAD
83):
Hole
ID
|
Easting
|
Northing
|
Elevation
|
Length
|
Dip
|
Azimuth
|
BR-260
|
456566
|
5635016
|
372
|
1200
|
-64
|
225
|
BR-261
|
456714
|
5634887
|
364
|
1284
|
-63
|
220
|
BR-262
|
456384
|
5635181
|
378
|
1110
|
-63
|
224
|
About the Dixie Project
The Dixie Project is 100% owned, comprised of 9,140 hectares of
contiguous claims that extend over 22 kilometres, and is located
approximately 25 kilometres southeast of the town of Red Lake, Ontario. The project is accessible
year-round via a 15 minute drive on a paved highway which runs the
length of the northern claim boundary and a network of
well-maintained logging roads.
The Dixie Project hosts two principal styles of gold
mineralization:
- High-grade gold in quartz veins and silica-sulphide
replacement zones (Dixie Limb, Hinge
and Arrow zones). Hosted by mafic volcanic rocks and localized
near regional-scale D2 fold axes. These mineralization styles
are also typical of the significant mined deposits of the
Red Lake district.
- High-grade disseminated gold with broad moderate to lower
grade envelopes (LP Fault). The LP Fault is a significant
gold-hosting structure which has been seismically imaged to extend
to 14 kilometres depth (Zeng and Calvert, 2006), and has been interpreted by
Great Bear to have up to 18 kilometres of strike length on the
Dixie property. High-grade gold mineralization is controlled
by structural and geological contacts, and moderate to lower-grade
disseminated gold surrounds and flanks the high-grade
intervals. The dominant gold-hosting stratigraphy consists of
felsic sediments and volcanic units.
About Great Bear
Great Bear Resources Ltd. is a well-financed gold
exploration company managed by a team with a track record of
success in mineral exploration. Great Bear is focused in the
prolific Red Lake gold district in
northwest Ontario, where the
company controls over 330 km2 of highly prospective
tenure across 5 projects: the flagship Dixie Project (100% owned),
the Pakwash Property (earning a 100% interest), the Dedee Property
(earning a 100% interest), the Sobel Property (earning a 100%
interest), and the Red Lake North Property (earning a 100%
interest) all of which are accessible year-round through existing
roads.
QA/QC and Core Sampling Protocols
Drill core is logged and sampled in a secure core storage
facility located in Red Lake Ontario. Core samples from the
program are cut in half, using a diamond cutting saw, and are sent
to Activation Laboratories in Ontario, an accredited mineral analysis
laboratory, for analysis. All samples are analysed for gold using
standard Fire Assay-AA techniques. Samples returning over 10.0 g/t
gold are analysed utilizing standard Fire Assay-Gravimetric
methods. Pulps from approximately 5% of the gold mineralized
samples are submitted for check analysis to a second lab.
Selected samples are also chosen for duplicate assay from the
coarse reject of the original sample. Selected samples with
visible gold are also analyzed with a standard 1 kg metallic screen
fire assay. Certified gold reference standards, blanks and
field duplicates are routinely inserted into the sample stream, as
part of Great Bear's quality control/quality assurance program
(QAQC). No QAQC issues were noted with the results reported
herein.
Qualified Person and NI 43-101 Disclosure
Mr. R. Bob Singh, P.Geo, VP
Exploration, and Ms. Andrea Diakow
P.Geo, Exploration Manager for Great Bear are the Qualified
Persons as defined by National Instrument 43-101 responsible for
the accuracy of technical information contained in this news
release.
ON BEHALF OF THE BOARD
"Chris
Taylor"
Chris Taylor, President and
CEO
Cautionary note regarding forward-looking
statements
This release contains certain "forward looking statements"
and certain "forward-looking information" as defined under
applicable Canadian and U.S. securities laws. Forward-looking
statements and information can generally be identified by the use
of forward-looking terminology such as "may", "will", "should",
"expect", "intend", "estimate", "anticipate", "believe",
"continue", "plans" or similar terminology. The forward-looking
information contained herein is provided for the purpose of
assisting readers in understanding management's current
expectations and plans relating to the future. Readers are
cautioned that such information may not be appropriate for other
purposes.
Forward-looking information are based on management of the
parties' reasonable assumptions, estimates, expectations, analyses
and opinions, which are based on such management's experience and
perception of trends, current conditions and expected developments,
and other factors that management believes are relevant and
reasonable in the circumstances, but which may prove to be
incorrect.
Such factors, among other things, include: impacts arising
from the global disruption caused by the Covid-19 coronavirus
outbreak, business integration risks; fluctuations in general
macroeconomic conditions; fluctuations in securities markets;
fluctuations in spot and forward prices of gold or certain other
commodities; change in national and local government, legislation,
taxation, controls, regulations and political or economic
developments; risks and hazards associated with the business of
mineral exploration, development and mining (including
environmental hazards, industrial accidents, unusual or unexpected
formations pressures, cave-ins and flooding); discrepancies between
actual and estimated metallurgical recoveries; inability to obtain
adequate insurance to cover risks and hazards; the presence of laws
and regulations that may impose restrictions on mining; employee
relations; relationships with and claims by local communities and
indigenous populations; availability of increasing costs associated
with mining inputs and labour; the speculative nature of mineral
exploration and development (including the risks of obtaining
necessary licenses, permits and approvals from government
authorities); and title to properties.
Great Bear undertakes no obligation to update forward-looking
information except as required by applicable law. Such
forward-looking information represents management's best judgment
based on information currently available. No forward-looking
statement can be guaranteed and actual future results may vary
materially. Accordingly, readers are advised not to place undue
reliance on forward-looking statements or information.
View original content to download
multimedia:http://www.prnewswire.com/news-releases/great-bear-doubles-vertical-extent-of-lp-fault-intersects-high-grade-gold-at-942-20-m-downhole-15-57-gt-gold-over-3-05-m-301257347.html
SOURCE Great Bear Resources Ltd.