SAN JOSE, Calif., Sept. 20, 2018 /PRNewswire/ -- Integrated
Device Technology, Inc. (IDT) (NASDAQ: IDTI) today announced the
release of its latest single lambda EML driver and TIA for
200G/400G datacenter applications.
Continuously increasing traffic in cloud data centers is driving
the demand for low-cost, high-speed optical interconnects, with low
power requirements. The sales of optical components and
modules for cloud data centers will increase 67% by 2023, with an
average annual growth rate of 20%, according to a 2018 report from
LightCounting. This high growth will be driven by the ongoing
adoption of 100GbE and the wider deployment of 400GbE.
The 400GbE based on 100G single lambda designs is expected to
establish an ecosystem to lower the cost per bit, a key enabler for
scalable Switch-to-Switch and Switch-to-Server Optical Links,
supported with small form factor modules, such as 200G/400G
QSFP-DD, OSFP and 400G OBO. The Electro-Absorption Modulated Laser
(EML) and Trans-Impedance Amplifier (TIA) are key analog IC
components, and the features of IDT's chip set of high bandwidth,
high sensitivity and low power consumption are promising to support
those modules.
The IDT® 100G single lambda EML Driver is available as a die
(HXT45100) and as a packaged driver (HXT45x01) with 1 or 4
channels. The driver family features broad bandwidth, high
linearity and low power consumption for the QSFP-DD module form
factor. The SMT-type packaged drivers integrate built-in Bias-T,
internal high-frequency chokes and input DC blocks, and offers 2Vpp
output voltage swing while consuming less than 300mW per channel
power. The bandwidth is over 40GHz with excellent phase
flatness and channel isolation.
The 100G single lambda TIA, offered as 1 channel and 4 channel
dies (HXR45x00), provides under 5kohm transimpedance gain,
500mVpp maximum differential output voltage, excellent flat
frequency response and low group delay with 3dB bandwidth higher
than 36GHz, is very suitable for 100G single lambda applications,
with a power dissipation as low as 168mW per channel. The HXR45x00
is configurable by I2C, for 28G applications, with a flat frequency
response and 3dB bandwidth of 25GHz and reduced power dissipation
down to 135mWper channel.
"We are very excited of the initial results of our single
channel and four channel 112G/ch TIA," said Andrea Betti-Berutto, IDT Fellow. "This new
generation of TIAs will well satisfy the high performance
challenges required for 100G single lambda applications and
simultaneously consume very little power and deliver a high
sensitivity solution for lower rate applications, such as
28Gbaud-based small form factor modules."
IDT will demonstrate the new chipset solution at ECOC 2018 in
partnership with MultiPhy's 100G single lambda DSP. MultiPhy's
FlexPhy PAM4 DSP platform is a low-power, high performance,
state-of-the-art single wavelength technology enabling data center
applications. MultiPhy's MPF3101, a 100G PAM4 single lambda DSP,
and its MPF3404, a 400G PAM4 DSP, are both powered by proven core
technology and a strong DSP engine, delivering unprecedented
performance and cost efficiency.
The demonstration will present a mature solution that includes a
fully functional MPF3404 400G 4x100G working in a breakout mode
with the MPF3101 100G DSP, delivering excellent BER and
stability.
MultiPhy's MPF3101 and MPF3404 products are both interoperable
between 100G and 400G transceivers, a key element for accelerating
the adoption of single lambda technology in data centers. The
devices are packaged in an advanced process mode and optimized for
use in QSFP28 and QSFP-DD modules.
"We are happy to create together with IDT a joint solution just
as 100G single lambda begins to dominate next generation
architectures in data centers," said Avi
Shabtai, CEO at MultiPhy. "Delivering a complete and mature
solution that has been tested and verified for its excellent
performance and stability leads the paradigm shift in the adoption
of DSP technologies for data center connections leveraging it to
optimize speed, cost and power and releasing the connectivity
barrier, satisfying the demand for the network evolution."
To see our live demo, please visit IDT at ECOC 2018, booth 448,
September 24-26 in Rome, Italy.
LightCounting is a market research firm focused on the in-depth
study of high speed interconnects for the datacom, telecom and
consumer communications markets. More information on LightCounting
and its reports is available at www.lightcounting.com.
About Multiphy
MultiPhy is the world leader in cutting edge
digital-signal-processing based integrated circuits for high-speed
communications. The company's 100G and 400G CMOS chipsets with
advanced PAM4 modulation schemes are leading in the technology
paradigm shift made necessary by the dramatic increase in network
traffic. MultiPhy's solutions make optical networks in Data Centers
faster, more scalable, flexible and cost-effective.
www.multi-phy.com.
About IDT
Integrated Device Technology, Inc. develops system-level
solutions that optimize its customers' applications. IDT's
market-leading products in RF, high performance timing, memory
interface, real-time interconnect, optical interconnect, wireless
power, and smart sensors are among the company's broad array of
complete mixed-signal solutions for the communications, computing,
consumer, automotive and industrial segments. Headquartered in
San Jose,
Calif., IDT has design, manufacturing, sales facilities
and distribution partners throughout the world. IDT stock
is traded on the NASDAQ Global Select Stock Market® under
the symbol "IDTI." Additional information about IDT can
be found at idt.com. Follow IDT on Facebook, LinkedIn,
Twitter, and YouTube.
© 2018, Integrated Device Technology, Inc. IDT and the IDT
logo are trademarks or registered trademarks of Integrated Device
Technology, Inc., and its worldwide subsidiaries. All other brands,
product names and marks are or may be trademarks or registered
trademarks used to identify products or services of their
respective owners.
IDT Press Contact:
Krista Pavlakos
Director, Demand Creation & Communications
Phone: 408-574-6640
E-mail: krista.pavlakos@idt.com
View original content to download
multimedia:http://www.prnewswire.com/news-releases/idt-announces-100g-single-lambda-eml-driver-and-tia-for-200g400g-datacenter-applications-300715847.html
SOURCE Integrated Device Technology, Inc.